Tag Archives: security

Configuring View security servers

I recently spent a very long time troubleshooting a View security server, documented in this post. As part of my sanity checking, I checked and rechecked all of the necessary settings for a security server paired up with a connection server. I didn’t find any helpfile or blog post that clearly spelled out what I needed to have configured, so I’m putting up a quick post.

This is the View connection broker that’s paired with the security server. The external URL and the PCoIP external URL are the private IPs of the connection broker itself. The security server in the DMZ must have access to these IPs. I won’t rewrite the firewall rules required, but check out KB1027217 for a detailed list of ports. The IP here is the IP that the security server sees for the connection broker. If you’re doing some kind of NAT from your DMZ to the inside, you’re going to have to key in the IP address on the DMZ side of the NAT.

View Connection Server

This is the paired security server. Here we use public IP addresses. This IP must be NATed externally to the private IP of your security server… unless of course you use public IP addressing inside your DMZ (yikes).

View Security Server

 

 

 

 

 

 

 

 

It’s not easy to test your changes externally. You could work remotely with multiple computers, one on the VPN to make your configuration changes and another testing connectivity from the public internet. That’s not always a feasible option for a consultant. You will typically not have a good way to test externally while inside the client’s network. I do a lot of work in education and many schools are built like bunkers – no cellular signal at all, so a MiFi or tethering is out as well. One easy way to test communication from the DMZ to the inside is to put a temporary VM in your DMZ segment. Give it an IP in the same subnet as your security server, and install the View client. In View, configure the security server to use the private DMZ IP instead of the public IP for the external URL and the PCoIP external URL. You can then test from your temporary VM. Once you get it working, change the external URL and the PCoIP external URL back to the public IP. Then you can get the external NAT and external firewall rules working – this is not a complex configuration and won’t require much trial and error.